Grandstream Networks HandyTone-488 User Manual page 18

Analog telephone adaptor for sw release version 1.0.2.6
Hide thumbs Also See for HandyTone-488:
Table of Contents

Advertisement

HandyTone-488 User Manual
End User
Password
IP Address
Time Zone
Daylight Savings Time This parameter controls whether the displayed time will be daylight savings
Cloned WAN MAC
Address:
LAN Subnet Mask
LAN DHCP Base IP:
DHCP IP Lease Time: Value is set in units of hours. Default value is 120hr (5 Days.) The time IP
DMZ IP:
Port Forwarding:
PSTN access code
Route Call to PSTN
This contains the password to access the Web Configuration Menu. This
field is case sensitive.
There are 2 modes under which the HandyTone ATA can operate:
- If DHCP mode is enabled, then all the field values for the Static IP mode
are not used (even though they are still saved in the Flash memory.) The
HandyTone ATA will acquire its IP address from the first DHCP server it
discovers from the LAN it is connected.
To use the PPPoE feature the PPPoE account settings need to be set. The
HandyTone will attempt to establish a PPPoE session if any of the PPPoE
fields is set.
- If Static IP mode is enabled, then the IP address, Subnet Mask, Default
Router IP address, DNS Server 1 (primary), DNS Server 2 (secondary) fields
will need to be configured. These fields are reset to zero by default.
This parameter controls how the displayed date/time will be adjusted
according to the specified time zone.
time or not. If set to Yes, then the displayed time will be 1 hour ahead of
normal time.
Allow the user to set a specific MAC address. Set in Hex format
Sets the LAN subnet mask. Default value is 255.255.255.0
Base IP for the LAN port which functions as a Gateway for the subnet.
Default value is 192.168.2.1
address are assigned to the LAN clients
Forward all WAN IP traffic to a specific IP address if no matching port is
used by HandyTone-488 itself or in the defined port forwarding.
Allow users to forward a matching (TCP/UDP) port to a specific LAN IP
address with a specific (TCP/UDP) port.
This field allows users to customize their own code to access the PSTN line.
Default is "*00".
If the dialed digits match one of the specified prefix here, outbound calls will
be routed to PSTN port. This field is especially useful for emergency calls.
18
Grandstream Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents