H-1200 Installations Instructions - Pentair EVERPURE H Series Installation Instructions Manual

6. INSTALL AND FLUSH FILTER CARTRIDGE
Q. Lift handle of the built-in shut off (QC Valve) on the
Head.
R. Hold Head firmly with one hand.
S. Align cartridge lug with label on filter Head.
T. Insert filter Cartridge – Push upwards.
U. Turn it to the right – About 1⁄4 turn – Until rotation
stops.
V. Open Side Valve of Angle Stop Adaptor and check
for leaks up to Inlet Elbow Fitting.
W. Open Filtered Water Faucet.
X. Lower the QC Valve Handle to flush water to the
sink.
NOTE: Flush new filter cartridges for at least
3 minutes (flush H-1200 system for at least 7
minutes) to remove air and any loose carbon. At
first the water may appear cloudy due to trapped
air in the filter and tubing. If water continues to
be cloudy for more than one week, please contact
Everpure Technical Services for assistance.
Y. Activate Filter Timer by pinching bubble until you
feel a change in resistance as the Filter timer
"pops". Within a few seconds, a thin RED line will
appear in the white window showing the Timestrip
has been activated. Peel away backing and adhere
to desired location. When the white window is
completely filled with RED, it is time to replace your
product.
H-1200 INSTRUCTIONS
Tools Needed For Installation
• Phillips Screwdriver
• Wrench
• Utility Knife
• Measuring Tape
• Pencil
1. OPEN CARTON & INSPECT PARTS
Installation Parts
Key Description
1 QL Twin Series Filter Head
2 Filter Cartridges (Set of 2)
3 2 Locking Washers
4 2 Screws
5 Angle Stop Valve Adaptor
6 Tubing, 1/4" poly
7 Elbow Fitting Pack
Restrictor
8 Plumbers Tape
9 Faucet Connector
10 Everpure Filter Timer
11 Shut Off Valve,
3/8" John Guest x 3/8" FPT
®
12 Coupler, 3/8" FPT
Stainless
6 • EVERPURE
H-Series Water Filtration Systems
®
6
V
Y
®
1
Part No.
1
EV927222
EV928201
EV306204
EV306196
EV312120
A0860119
EV308168
EV312119
EV312135
EV314160
EV309860
EV312350
Q
S
Label
Lug
R
T
W
4
3
6
2
9
U
X
5
8
7
11
10
12