Advertisement
『
Safety Precautions Installation
This symbol is intended to remind the user the presence of actions and operation that may cause danger.
Please read instructions carefully and follow the instructions to avoid any danger.
This symbol is intended to represent precautions that the user should follow to prevent danger.
WARNING
Serious injury might result if the following precautions are not followed.
• The installation should be performed by certified workers under the relevant regulations of end user's
country / region.
• Never modify or disassemble LED lighting arbitrarily because it can cause serious accidents.
• Never use any input power except the listed rated voltage. If not, it can cause serious accidents.
• Before installation, shut off the power supply and verify it is de-powered using a measuring instrument.
• The wiring should be insulated under end user's respective region's Electric Installations Standards.
• Do not install in a wet environment.
CAUTION
The user may be injured or there would be property damage if the instructions below are not followed.
• Do not forcefully pull on AC/DC lines when wiring up the lighting. (It causes the wires to snap.)
• Do not use this product for any purposes other than what's specified.
The manufacturer or sellers are not responsible for breakdowns or accidents caused by its improper use.
• When connecting the wires, use proper connection terminals depending on the site of installation.
Do not install in a wet environment.
• Make sure to ground fixture by contacting it to metals around it to prevent damage by static.
• The product may be damaged if static is not removed.
• During the operation, be careful not to disconnect the wires.
• Make sure the grounding is performed under Electricity Standards.
• Using it for any voltage other than specified can cause failure or fire.
• Do not use it in moist environment.
• Be mindful of proper ventilation of product.
• Improper installation or disassembly causes a deformation or breakdown of the product.
• Consider proper protection devices, such as circuit breakers, fuses, switches, etc. for safety precautions.
• Do not install in an enviroment with excessive vibration.
• Do not handle product with contaminated hands or gloves.
• In any event, do not store / install in a contaminated place.
•
Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
•
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
•
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
』
Advertisement
