Advertisement
R
STEP. 22
Once the AC power cable is connected, arrange the
internal wiring well and close the SMPS cover like the
following figure:
STEP. 23
This product is structured to control the lighting sur-
face by 5° in vertical direction.
Please remember the default of the product is set to 0°
when it is shipped out from the factory.
Do not disassemble the fixing bolt for angle setting.
The lamp may rotate downward to damage the prod-
uct.
STEP. 24
Remove the fixing bolts in front to raise the lamp by
5°.
Push the lamp upward whiling aligning its second
and fourth bolt holes with the corresponding light
pole holes and bolt parts together for fixing like the
following figure:
Put the bolts through the points where both holes
are aligned and tighten them firmly.
Street Light
(HR)
Installation & Operation User Guide
The information in this document is subject to change without notice
Copyright 1991 ~ 2012 KMW, INC. All Rights Reserved
©
Document Revision V0.61 2013.01.15
16
Pages
Advertisement
