Advertisement
R
STEP. 25
Remove the fixing bolts in front to lower the lamp
by 5°.
Push the lamp downward whiling aligning its first
and third bolt holes with the corresponding light
pole holes and bolt parts together for fixing like the
following figure:
Put the bolts through the points where both holes
are aligned and tighten them firmly.
STEP. 26
Use a 17 mm spanner to tighten the fixing bolts on
the lamp side. In this case, both sides shall be tight-
ened.
STEP. 27
Now, HR Product installation is completed.
Turn the main power switch on to check if the prod-
uct is working properly.
Street Light
(HR)
Installation & Operation User Guide
The information in this document is subject to change without notice
Copyright 1991 ~ 2012 KMW, INC. All Rights Reserved
©
Document Revision V0.61 2013.01.15
17
Pages
Advertisement
