Advertisement
R
STEP. 04
As the sun rises from the east and sets to the west,
you must direct the Brightness Sensor Receptacle to
the north for normal operation of the product.
To begin with, use a driver to loosen both bolts like
the following figure:
If you don't use the Electronic Auto Switch, skip the
above step and jump to Step 10.
STEP. 05
Swing the receptacle horizontally and set it as close
as to the north on the basis of the arrow (north)
marked on top. Be sure to align the receptacle bolt
holes with those of the apparatus to bond them with
fixing bolts.
There are several bolt fixing holes at the bottom of
the receptacle.
STEP. 06
Direct the receptacle to the north and tighten two
bolts in the reverse order of the disassembly until the
connector is fixed to the apparatus.
Street Light
(HR)
Installation & Operation User Guide
The information in this document is subject to change without notice
Copyright 1991 ~ 2012 KMW, INC. All Rights Reserved
©
Document Revision V0.61 2013.01.15
Bolt holes
10
Pages
Advertisement
