Table of Contents
Advertisement
POSEIDON PE
4.2
Start the washer
4.2.1 Switching on the
washer when it is
connected to a water
supply
4.2.2 Switching on the
washer when it is
connected to open
tanks (suction mode)
10
1. Start the engine. (See the
operating manual for the fuel
engine.)
1. Before connecting the suction
hose to the washer, fi ll the
hose with water.
2. Start the washer.
3. Unlock the spray gun and
activate it.
4. When using this machine in
suction mode, fi rst ensure
that the system has been
bled of air by letting the
machine run without spray
lance mounted until all air
has escaped.
During work breaks of more
than three minutes, switch off
the washer.
2. Unlock the spray gun and
activate it.
3. Lock the safety catch even
during short pauses.
NOTE!
Activate the
spray gun several
times at short intervals to vent
the system.
If it requires too much power to
start the engine, it can be
facilitated by removing the
spray lance and activate the
spray gun during startup.
NOTE!
For automatic
suction from a tank,
watercourse or similar sup ply,
the inlet hose must be fi lled
with water before you start. The
suction height
depends on the water
temperature. Max. suction
height (see section 8.3
Technical Data) is reached with
cold water (up to 8°C). With
70°C/60°C warm water, the
ma chine must be under or at
the water level.
If the water being suctioned
contains particles, a suction
fi lter must be mounted on the
end of the hose.
In case of risk of running sands,
a sand fi lter must be attached.
Original Instructions
Hide quick links:
Advertisement
Table of Contents
