Table of Contents
Advertisement
4.
Pull out the metal blanking plate from the front of the internal
drive bay metalwork.
5.
Carefully slide the new drive into the bay from the front and
secure it on both sides using the special screws provided with the
drive.
6.
Attach a spare power cable to the drive (it does not matter
greatly which of the available power cables you choose).
7.
If you are fitting a SCSI device that has a 50-pin connection,
connect using a 50-68 pin adapter to the existing SCSI cable
connected to channel 'A'.
◊ Remember to check 'Termination rules' on the first page of
this chapter.
8.
Attach any other signal cables as instructed in the
documentation supplied with the removable-media drive.
9.
Check to ensure that no other cables or connections have
become dislodged or trapped during the work, then refit the
system unit panels.
Finally, follow any further instructions supplied with the drive (for
example, installing and configuring software).
S C S I d r i v e s
FT1200 HANDBOOK
4/7
Advertisement
Table of Contents
