Alinco DJ-X11 Instruction Manual page 98

12. Cable-clone and PC Connection Functions
● Precautions common to all connections
• Be sure to turn off both the DJ-X11 and external device before
• The earphone jack of the DJ-X11 accepts a ø3.5 mm 4-pole stereo
● Applicable plugs
(Wiring of 4-pole plug)
The earphone jack of the DJ-X11 is wired as follows. Refer to the
diagrams when you make a cable yourself. It is impossible to change the
signals output to the terminals on the DJ-X11 side. Take other measures
such as changing the wiring of the cable or changing the input setting of
your receiving software.
(Use of a cable with 3-pole plugs)
Terminals are arranged from the top in the order of the audio output
(monaural) terminal, data signal output terminal (cloning, detected signals,
IQ signals), and grounding terminal. The part for the remote control signal
12
terminal for the EDS-12 in a 4-pole plug can be ignored.
(Use of 2-pole monaural plugs)
If you use the DJ-X11 only to output signals to an earphone, an external
speaker, ACARS software, or a low-speed packet TNC, you can use a
cable, an earphone, or an external speaker with ø3.5 mm 2-pole monaural
plugs. The earphone antenna function of the DJ-X11 can be used even
with third-party earphones of such a structure. When you use these
devices, set the DJ-X11 not to output detected signals and IQ signals.
98
establishing any connection.
mini-plug. Refer to the diagrams below for wiring. A commonly-available
3-pole plug cable can also be used because the remote control terminal
can be connected to the ground even while the EDS-12 is used and this
terminal is not used for cable-cloning or PC connection.
Data signal output terminal
(Cloning, detected signals, IQ signals)
Grounding terminal
Remote control terminal when the EDS-12 is used
Audio output (monaural) terminal
To the earphone jack on the
Master DJ-X11
(Cloning, detected signals, IQ signals)
Audio output (monaural) terminal
To the earphone jack of the
Data signal output terminal
Grounding terminal
Slave DJ-X11