Switching The Modulation Mode - Alinco DJ-X11 Instruction Manual

8. Functions Assigned to the Key Pad

8-3 Switching the Modulation Mode

Select the modulation mode to use to receive signals manually.
Tune to the frequency you want to receive in advance.
1
Press the [FUNC] key to display
2
Press the
3
"Modulation mode" on the LCD.
Rotate the upper dial to switch
4
the modulation mode.
The modulation modes for the main band are switched as follows:
The modulation modes for the sub band are switched as follows:
8
CAUTION
50
key to display
Auto FM WFM
Auto FM AM
• The modulation modes which can be selected for the sub band are AM
and FM only.
• Since the SSB/CW reception of the DJ-X11 uses a simple circuit, the
performance against interference or suppression is inferior to commu-
nication receivers, however, this is not a malfunction. Sometimes USB
can be demodulated with LSB depending on the signal strength.
• The fi lter is common to CW and SSB and does not support the Narrow mode.
• To receive frequencies lower than the short wave band where SSB
and CW are frequently used, it is especially important to install an ap-
propreate external antenna.
on the LCD.
VFO
Modulation mode
Auto
AM USB LSB
B S
145.000
CW
F M