Programming A Memory Channel - Alinco DJ-X11 Instruction Manual

7-2 Programming a Memory Channel

This section describes how to program a memory channel with the DJ-X11.
• For easy understanding, it is recommended to read this page once and
then actually operate the receiver according to the programming ex-
MEMO
ample shown on (P. 37).
In VFO mode, set the desired frequency and the Tone
1
Squelch function in advance.
You can program the following items in a memory channel.
• Frequency
• Tone frequency
• DCS code
• Modulation mode (reception mode)
• Tone squelch/Reverse tone squelch/DCS
• Memory name
• Skip setting
Press the [FUNC] key.
2
Refer to the table on the next page and rotate the dial to
3
select the bank and memory channel to be used for pro-
gramming.
To program the frequency for the main band, use the main dial to select
the bank and memory channel.
To program the frequency for the sub band, use the sub dial to select the
bank and memory channel.
If a memory channel which has already been programmed is selected, "MR"
is displayed on the LCD.
• Rotate the lower dial to change the bank type and rotate the upper dial to
change the memory channel.
7. Memory Mode
7
35