Choosing Movement Direction; How To Connect Power - Elite CSW-200-UL series Instruction Manual

CENTER SAFETY EXIT
DC-BACKUP
W4
GB A
MS LINK SYSTEM ON TIMER POWER
SENSORS
60 3
OVERLOAD
13
OFF ON
13 13
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO GATE
DEPT. OPEN RECEIVER LOCKED
EXIT SAFETY CENTER RESET
LOOP LOOP LOOP MOTOR
OPEN TO THE RIGHT
White Wires
Black Wires
(Neutral)
(120 VAC)
Green Wires (Ground)
WIRE GUAGE REQUIREMENT FOR 120 VAC POWER SUPPLY: 1/2 HP AND DUAL MOTOR ONLY
16 Gauge 14 Gauge
150 Feet 250 Feet
Caution: ELITE ACCESS SYSTEMS, INC. is not responsible for conflicts between the information listed in the above chart and the requirements
of your local building codes. The information is for suggested use only. Check your local codes before installation.
MER
60
1 3
OFF ON
OPEN LEFT
OPEN RIGHT
RADIO
Do Not Use This Outlet Unless You Are
An Authorized Service Technician
Suggestion:
Seal all open holes of
electronic box with
sealant when finished
wiring.
Use U.L. Listed Conduit
for Supplying Power to
the Unit
12 Gauge 10 Gauge
400 Feet
OPEN TO THE LEFT
MER
60
1 3
OFF ON
OPEN RIGHT
OPEN LEFT
RADIO
Gate Operator MUST be Properly Grounded
8 Gauge
650 Feet 1000 Feet
CENTER SAFETY EXIT
DC-BACKUP
W4
GB A
MS LINK SYSTEM ON TIMER
SENSORS POWER
60 3
OVERLOAD
13
13 13 OFF ON
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO GATE
DEPT. OPEN RECEIVER LOCKED
EXIT SAFETY CENTER RESET
LOOP LOOP LOOP MOTOR
Minimum:
15-amp
breaker
switch per
operator
needed
4 Gauge
2200 Feet