Master And Slave With Timer On - Elite CSW-200-UL series Instruction Manual

Master and Slave Boards are Interchangeable
Caution:
115 volts per operator required
Master Omni Board
CENTER SAFETY EXIT
W4
G B A
SYSTEM ON
MS LINK
SENSORS
1 3 1 3
OPEN LEFT
FIRE STRIKE
DEPT. OPEN
EXIT SAFETY
LOOP LOOP
W4
G B A
MS LINK
1. Connect G from master to
(G is the shield or a ground wire)
2. Connect B from master to
3. Connect A from master to
4. Turn timers on BOTH Omni boards to the "ON" position
5. Turn the SLAVE Timer adjustment all the way Counterclockwise
6. Use MASTER timer ONLY to select the desired time
Use Low Voltage Wires to Connect Gate Operators Together
TIMER
OFF
OPEN LEFT
DC-BACKUP
Master Timer "ON"
TIMER
POWER
60 3
OVERLOAD
1 3
OFF ON
OPEN RIGHT
RADIO GATE
RECEIVER LOCKED
CENTER RESET
LOOP MOTOR
Use Shielded
Twisted Wires
to Connect Gate
Operators Together
G of slave.
B of slave.
A of slave.
Master Omni Board Primary Control for System
60 3
Adjust Time Desired
1 3
ON
0 to 60 seconds
OPEN RIGHT
CENTER
W4
W4
G B A
MS LINK
Slave Omni Board
SAFETY EXIT
DC-BACKUP
G B A
MS LINK SYSTEM ON TIMER
POWER
SENSORS
60 3
OVERLOAD
1 3
OFF ON
1 3 1 3
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO GATE
DEPT. OPEN RECEIVER LOCKED
EXIT SAFETY CENTER RESET
LOOP LOOP LOOP MOTOR
MAXIMUM
Counterclockwise
Setting
TIMER
60 3
1 3
ON
OFF
OPEN LEFT OPEN RIGHT
Slave Timer "ON"