Table of Contents
Advertisement
5.5 Restore Factory Default Settings
The WNAP-6300 provides two ways to restore the factory default settings:
Restore factory default settings via Web
From "Configuration File", clicking "Reset" will eliminate all current settings and reboot your
device, then default settings are applied.
Restore factory default settings via Reset Button
If software in WNAP-6300 is unexpectedly crashed and no longer reset the unit via Web, you may
do hardware reset via the reset button. Press and hold the button for at least 5 seconds and then
release it until the PWR LED gives a blink.
5.6 Reboot
You can reboot your WNAP-6300 from "Configuration File" in "Management" as below:
Click "Reboot" and hit "Yes" upon the appeared prompt to start reboot process. This takes a few
minutes.
Chapter 5 Management
Figure 20 Restore Settings
Page 44
Advertisement
Table of Contents
