Configure Snmpv3 User Profile - Planet WNAP-6300 User Manual

By default, it is set to public and allows all requests.
Set Community
Specify the password for the incoming Set requests from the management station. By default, it is
set to private.
Trap Destination
Specify the IP address of the station to send the SNMP traps to.
Trap Community
Specify the password sent with each trap to the manager. By default, it is set to public and allows
all requests.

Configure SNMPv3 User Profile

For SNMP protocol version 3, you can click "Configure SNMPv3 User Profile" in blue to set the
details of SNMPv3 user. Check "Enable SNMPv3 Admin/User" in advance and make further
configuration.
Chapter 5 Management
Figure 32 Configure SNMPv3 User Profile
Page 40