Gear Heat Assy - Oki OKIPAGE8c Maintenance Manual

3.3.12 Gear Heat Assy

1. Remove the cover assy side (R), cover assy OP panel, cover front (R) and the cover rear (L).
(See 3.3.8)
2. Remove the cover CU then unplug all the cables connected to the PXS PCB and unscrew 3
screws. (See 3.3.11)
3. Unplug all the cables connected to the PXF PCB then remove the PX4 PCB. (See 3.3.11)
(Be careful not to damage the connector when unplugging cables connected to the PXF
PCB.)
4. Remove the heat unit assy. (See 3.3.40)
5. Remove the guide paper eject assy. (See 3.3.3)
6. Remove the motor fan (80-25). (See 3.3.2)
Unscrew 5 screws 1 and unplug the cable 2 then remove the guide heat assy 3.
7.
8. Unscrew 2 screws 4 then remove the motor (ID)5.
1
1
5
Figure 3.3.12 Gear Heat Assy
3 - 19
1
2
4
3