Oki OKIPAGE8c Maintenance Manual page 121

Category LCD Status
Message
Interface Jam 001 Undefined
Error Error
ERROR HOST I/F Undefined
OKI HSP xx
Controller EEPROM Undefined
Error RESETTING
ERROR POSTSCRIPT Undefined
LED
K C M
Undefined Undefined Undefined
Undefined Undefined Undefined
Undefined Undefined Undefined
Undefined Undefined Undefined
Y READY ATTENTION
OFF Blink Indicates that Process error occurred.
OFF Blink Indicates that a fatal OKI HSP interface error has
occurred.
xx=10: Interface timeout
xx=20: Initialization failed 10 seconds after the page
xx=21: It takes 3 seconds or more before the RUN
xx=22: HSP-PC communication error
OFF Blink Indicates that the ID number of EEPROM is invalid.
Blink OFF Indicates that the interpreter detected one of the
errors given below. The data coming after this error
is recovered until the end of the command. When
the reception of the command is completed, this
message is reset automatically.
- Invalid PostScript command
- The page is complicated and the vertical memory
is full.
Trouble or Status
printer is powered on.
mode starts or the page printer received a
Run Mode command in the power-on mode.
Remedy
Notifies that the power supply LSI
has been reset due to noise, etc.
(process error)
Open cover and remove the paper.
Close cover to recover and proceed.
The page printer recovers from the
error when the RECOVER switch is
pressed. If this error occurs fre-
quently, replace the OKI HSP inter-
face card or the main board (PCR
PCB).
Sets the default values in EEPROM
and it'll be recovered automatically.
Simplify the pages.