System Maintenance Mode - Oki OKIPAGE8c Maintenance Manual

4.1.2

System maintenance mode

To set the system maintenance mode, turn on the power switch of the page printer while pressing
on the Recover key.
Note: The system maintenance mode is hidden and not available to the user.
To exit this mode, press the ONLINE switch except during rolling ASCII continuous printing. Then
the RUN mode is set.
In the system maintenance mode, the category changes each time the MENU switch is pressed.
The last category wraps around to the first category. The system maintenance mode supports the
following functions:
• Page count display
• Rolling ASCII continus prinitng
• HSP ERROR recovery
• HSP ERROR count reset
(1) Page count display
• The total number of pages counted at the engine is displayed on the LCD.
(2) Page count printing enable/disable
• This function selects whether to include (enable) or exclude (disable) the total number of
printed pages counted at the engine at the time of menu printing.
(3) Rolling ASCII continuous printing
• The rolling ASCII pattern is printed continuously for various engine tests.
• Press the ON-LINE key to cancel this mode.
(4) EEPROM reset
• All EEPROM areas including Menu level-2 to the factory default values.
• The following items are excluded
Head drive time setting
ENGINE Maintenance Item
Revision (Including Destination setting)
(5) HSP ERROR recovery
• Select HSP ERROR recovery function either recover or stop.
(6) HSP ERROR count
• Display total HSP ERROR count.
(7) HSP ERROR count reset
• Reset the HSP ERROR counter.
• Page count printing enable/disable
• EEPROM reset
• HSP ERROR count display
4 - 5