Cover - Oki OKIPAGE8c Maintenance Manual

3.3.8

Cover

Describes the method of removing the cover assy side (L)/(R), cover assy OP panel, cover front
(L)/(R) and the cover rear (L).
1. Remove the cover assy rear. (See 3.3.1)
2. Remove the cover assy stacker. (See 3.3.4)
Unscrew 2 screws 1 then remove the frame side (L) 2.
3.
Unscrew 2 screws 3 then release the lock of the claw with the cover assy side (R) 4 lifted
4.
a little bit, then remove the cover assy side (R).
5. Unplug the operator panel cable 5 from the PCM PCB.
6. Open the FDR unit front in the arrow direction.
Unscrew 2 screws 6 then remove the cover assy OP panel7.
7.
Unscrew 2 screws 8 then release the lock of the claw with the cover front (R) 9 pushed up
8.
then remove the cover front (R).
9. Unscrew 2 screws 0 then remove the cover front (L) A.
10. Unscrew 2 screws B then remove the cover rear (L) C.
11. Pull off the film E glued on the cassette guide.
11. Release the engagement with the guide by lifting the cover assy side (L) D, then remove the
cover assy side (L).
B
1
2
C
A
E
A
D
0
Figure 3.3.8 Cover
6
A
3 - 15
7
5
3
4
8
9
Pushed Up
FDR Unit Front