3.3.5 Gear Case Assy
(1)
Remove the printhead (see 3.31).
(2)
Remove the upper cover (see 3.3.4 (1) – (5)).
(3)
Move the carriage Assy to right hand side, remove two screws 1, then the space motor 2.
(4)
Disconnect a carriage cable.
(5)
Disengage claws (4 places).
Using a flat-blade screwdriver, push to widen the claw for easy disengagement.
(6)
Remove the gear case Assy 3 in upper direction and release the carriage cable from the
cable clamp of the gear case Assy.
(7)
To install, follow the removal steps in the reverse order.
Note on installation:
(1) To assemble, align the direction of the SP motor axis 4 with the Gear Hole of the
Gear Case assy.
(2) Be sure to check, and adjust if necessary, the gap between platen and printhead (see
4-1).
4
42113901TH01 Rev.3
2
1
Oki Data CONFIDENTIAL
3
61 /