Fujitsu FI-4860C2 Installation Manual page 44

10. Your computer is restarted and the scanner wil be detected. Do not
remove the Setup CD-ROM from the CD drive until your PC will be
completely restarted.
ATTENTION
Now the installation of the scanner driver is completed.
ATTENTION
22 2.3 Installing the Scanner Driver and Application
Depending on the OS, the following operations may be necessary.
For Windows 98:
When a request for inserting the CD-ROM of Winows 98 appears, insert it
into the CD drive and click the [OK] button.
For Windows 2000:
When [Digital Signature not Found] appears, click [Yes].
For Windows XP:
1. When [Found New Hardware Wizard] window appears,select "No, not
this time" and click the [Next >] button. (This window only appears when
the Service Pack 2 is installed.)
2. Then select "Install the software automatically" and click the [Next >].
3. When any alarm is displayed on [Hardware Installation] window, click
the [Continue Anyway] button.
4. Click the [Finish] button.
For confirming if the installation was successful, perform a scanning oper-
ation by using an application that complies with the TWAIN standard such
as ScandAll 21.