As Needed - HearthStone DVI 44 Owner's Manual

Hearthstone Quality Home Heating Products, Inc.
Professional Inspection
Once a year, have the unit, and venting system
inspected by qualified service personnel to ensure
that they are clean, free of obstruction, safe, and in
good working order. If service or maintenance is
required, have qualified service personnel perform it.

As Needed:

Accent Light Bulb Replacement
1. Ensure the unit is off (or unplugged).
2. Ensure the insert is cool – dismount the façade
(see page 32).
3. Remove the screen, and glass (see page 18).
4. Grasp the light housing (will be hot if the light
was just on) – slightly squeeze inward on the
front and rear sides on the bottom of the housing
near the firebox –slide to the right and lift the
housing to disengage the tangs. Pull the housing
out of the convection chamber and rotate it up to
access the halogen bulb.
5. Carefully remove the old bulb by pulling the
prongs out of the socket. Replace only with a
GY6.35 Base, JC Bi Pin, 50 watt, clear, 120 volt
bulb. Do not touch the new halogen bulb with
your bare fingers – keep the plastic sleeve over
the bulb, or use clean cotton gloves when
installing.
6. Reinstall the housing, glass, screen, and façade.
Glass and Gasket Replacement
In the event that you need to repair or replace a
cracked or broken glass or worn gasketing, use the
following instructions to replace the components. For
a broken front glass ask for kit 98-58600 from your
Authorized Hearthstone Dealer. Your DVI 44 uses a
'tadpole' fiberglass gasket to make a tight seal
between the glass frame and the firebox. In time, the
gasket can become brittle and compressed and
should be replaced. New gasket material is also
available from your Authorized Hearthstone Dealer.
Protect your hands with work gloves, and wash up
thoroughly after installation. Do not use substitute
materials. Only use parts provided by an Authorized
Hearthstone Dealer.
1. Allow the DVI 44 to cool completely. Dismount
the front façade.
2. Remove the glass frame. See the firebox access
instructions on page 18.
Figure 37 – Glass Frame Removal Detail
3. Dismount the front glass assembly by releasing
the upper spring clips – then lift the frame up
and out of the lower retainer. Be careful with
the broken glass.
4. Reattach the new glass and glass frame
assembly to the stove.
39
DVI-44 Model 8860