Nilfisk-Advance SW8000 Service Manual page 206

Service Manual – SW8000
Adjustments
To Set the Drive Pump Neutral Position
1. Jack up the rear of the machine to get the drive wheel up off the ground.
2. Install safety blocks or stands to support the rear of the machine.
3. Remove the center cover assembly/DustGuard
Note: If your machine is equipped with a DustGuard
coupling on the DustGuard
4. Start the engine and observe the
wheel rotation with the engine
idling. If the wheel is rotating
either forward or reverse with the
foot pedal in the neutral position,
adjust the position of the
as follows:
Weldment
5. Loosen the two
1/4"-20 x .62"
holding the
Screws Lever
.
Lever Weldment
6. Rotate the
Lever Weldment
necessary until the wheel stops
turning.
7. Tighten the two
1/4"-20 x .62"
.
Screws
8. Shut the engine off.
9. Reset the foot pedal deadband
setting. (Refer to the Control
System/Main Machine Controller
Programming/Hydrostatic Neutral
Position and Dead-band
10. Reinstall the center cover assembly/
DustGuard tank.
™
11. Reconnect the DustGuard
coupling (if applicable).
tank to access the forward/reverse controls.
™
tank before you remove the DustGuard
™
Lever
to the
as
section.)
tank hose
™
system, you'll need to disconnect the hose
™
Lever
Weldment
Lever
Weldment
Wheel System, Traction
tank from the machine.
™
Lever
1/4"-20 x .62"
Screw (2)
1/4"-20 x .62"
Screw
Lever
1/4"-20 x .62"
Screw
206