Nilfisk-Advance SW900 User Manual
Nilfisk-Advance SW900 User Manual

Nilfisk-Advance SW900 User Manual

Sweeper
Hide thumbs Also See for SW900:

Advertisement

USER MANUAL
TRANSLATION OF ORIGINAL
INSTRUCTION
08/2013
(1)
1465371000
Model: 9084111010
SW900
USER MANUAL
DEUTSCH
FRANÇAIS
ENGLISH
NEDERLANDS
G

Advertisement

Table of Contents
loading

Summary of Contents for Nilfisk-Advance SW900

  • Page 1 08/2013 DEUTSCH FRANÇAIS ENGLISH 1465371000 NEDERLANDS Model: 9084111010 SW900 USER MANUAL TRANSLATION OF ORIGINAL USER MANUAL INSTRUCTION...
  • Page 2 Тип / Typ / Typ / Type / Tipo / Tüüp / Type / Tyyppi / Type / Τύπος / SW900 Típus / Tipo / Tipas / Tips / Type / Type / Tipo / Typ / Tip / Тип / Typ / Typ / Tip / Tip : Сериен...
  • Page 3: Table Of Contents

    SIDE BROOM DISASSEMBLY/ASSEMBLY ..........................16 SKIRT HEIGHT CHECK AND ADJUSTMENT ..........................17 DUST FILTER CLEANING AND INTEGRITY CHECK ........................18 HOPPER POSITION MICROSWITCH OPERATION CHECK ....................... 19 FUSE CHECK/REPLACEMENT/RESET ............................19 TROUBLESHOOTING ..............................20 SCRAPPING .................................. 20 1465371000 - SW900...
  • Page 4: Introduction

    All necessary operating, maintenance and repair procedures must be performed by qualified personnel or by Nilfisk Service Centers. Only original spare parts and accessories must be used. Contact Nilfisk for service or to order spare parts and accessories, specifying the machine model, product code and serial number. SW900 - 1465371000...
  • Page 5: Changes And Improvements

    Internal combustion engine. Hot parts, danger of burns. Do not inhale exhaust gas fumes. Carbon monoxide (CO) can cause brain damage or death. WARNING! WARNING! Do not wash the machine with direct or Moving parts. pressurised water jets. 1465371000 - SW900...
  • Page 6: Symbols That Appear On This Manual

    Stop the engine before performing any procedure on it. To avoid any accidental start, disconnect the spark plug cap. – See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this Manual. SW900 - 1465371000...
  • Page 7 Technical service procedures on the engine must be performed by an authorised Dealer. – Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality can seriously damage the engine. 1465371000 - SW900...
  • Page 8: Machine Description

    Hour counter 23. Left door opening/closing knob Drive control lever 24. Front skirt Drive system control adjuster 25. Rear skirt 10. Handlebar 26. Side skirts 11. Handlebar tilting adjusting lever 12. Right side broom lifting/lowering lever P100830 SW900 - 1465371000...
  • Page 9 35. Engine model 47. Serial number plate/technical data/conformity certification 36. Engine serial number 48. Vacuum fan 37. Engine oil filler/level check plug 49. Driving belt 38. Engine oil drain plug 50. Main broom belt 51. Right door P100831 1465371000 - SW900...
  • Page 10: Accessories/Options

    Machine sound pressure level (ISO 3744, ISO 4871, EN 60335-2-72) (LwA) 93 dB(A) IP protection class U-turn space 1550 mm Vibration level at the operator’s arms (ISO 5349-1) (**) 4 m/s With fuel and empty hopper. (**) Under normal working conditions, on a level asphalt surface. SW900 - 1465371000...
  • Page 11: Wiring Diagram

    USER MANUAL ENGLISH Machine material composition and recyclability Type Recyclable SW900 P weight percentage percentage Aluminium 100 % 2.2 % Electric motors - various 29 % 18.8 % Ferrous materials 100 % 35.5 % Wiring harnesses 80 % 1.6 %...
  • Page 12: Use

    While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see the Visible Symbols On The Machine paragraph). Do not cover these plates for any reason and immediately replace them if they are damaged. SW900 - 1465371000...
  • Page 13: Before Machine Start-Up

    (12) and (13, optional) backwards. NOTE The side brooms turn on when lowered and can be lowered and lifted even when the machine is moving. Start sweeping by grasping the handlebar (10) and pulling the drive control lever (8) gradually. 1465371000 - SW900...
  • Page 14: Machine Operation

    Slightly lift the machine so that the skirts, the main broom and the wheels do not touch the ground. FIRST PERIOD OF USE After the first 20 hours, or after the first month, change the engine oil (see the procedure in the Petrol Engine Manual). SW900 - 1465371000...
  • Page 15: Maintenance

    (4) Maintenance procedures to be performed by an authorised Honda Dealer, unless the operator has the service equipment and data, and is qualified to perform such procedures. (5) For the relevant procedure, see the Petrol Engine Manual. (6) The first time after 20 hours or after one month. 1465371000 - SW900...
  • Page 16: Main Broom Height Check And Adjustment

    4 cm), the machine regular operation is affected and the moving parts or electrical components can overheat, thus reducing machine life. Pay careful attention when performing the above- mentioned checks, and always use the machine P100818 according to the indicated conditions. Figure 5 SW900 - 1465371000...
  • Page 17: Main Broom Replacement

    10. Install the new main broom on the front side of the machine, and ensure that the mesh (G) properly fits into the relevant drive hub (E). 11. Install the main broom cover (C) and tighten the knobs (B). 12. Close the left door (A). 13. Adjust the main broom height as shown in the previous paragraph. P100819 Figure 6 1465371000 - SW900...
  • Page 18: Side Broom Height Check And Adjustment

    Install the new broom on the machine engaging it on the pins (C), then tighten the knob (A). Adjust the height of the new broom according to the procedure shown in the previous paragraph. P100822 Figure 9 SW900 - 1465371000...
  • Page 19: Skirt Height Check And Adjustment

    18. When the adjustment is completed, tighten the screws (L). P100825 Figure 11 19. Assemble the components in the reverse order of disassembly. NOTE The front skirt (24) on the hopper does not require to be adjusted. P100826 Figure 12 1465371000 - SW900...
  • Page 20: Dust Filter Cleaning And Integrity Check

    Pre-filter Cleaning (optional) 11. Perform steps 1 to 3. 12. Remove the pre-filter (K, Fig. 16) and clean it with compressed air at maximum 6 Bar. 13. Assemble the components in the reverse order of disassembly. P100829 Figure 15 SW900 - 1465371000...
  • Page 21: Hopper Position Microswitch Operation Check

    Disengage the front latch (22) and open the engine and dynamotor hood (21). Check/replace the relevant fuse among the following: (29): Main fuse FA (20 A). (30): Electrical filter shaker fuse F1 (5 A). Reassembly Close the engine and dynamotor hood (21) and engage the front latch (22). 1465371000 - SW900...
  • Page 22: Troubleshooting

    Law in force: – Engine oil – Polyester dust filter – Main and side brooms – Plastic hoses and components – Electrical and electronic components (*) Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components. SW900 - 1465371000...

Table of Contents