On-Board Circuits - Notifier

ID50 Installation, Comissioning & Configuration Manual

Output No. Type
1 (B01) Fixed Monitored
Output Circuit (A)
2 (B02) Fixed Monitored
Output Circuit (B)
3 (B03) Hardware Configurable Can be configured for operation as a Monitored Output
CFG Output Circuit (C) (Sounder Circuit or Relay Circuit) or as an
4 (B04) Hardware Configurable Can be configured for operation as a Monitored Output
CFG Output Circuit (D) (Sounder Circuit or Relay Circuit) or as an
5 (B05) -VE Output Circuit (1)
6 (B06) -VE Output Circuit (2)
2
Description
Monitored Sounder (SDR) or Monitored Control
Module (CTL) or Transmission Device (TxD) can be
programmed for Fire Alarm, Fault, Pre-Alarm or Plant
Warning CBE Rules.
Factory Default = Fire Alarm - All Zones.
Monitored Sounder (SDR) or Monitored Control
Module (CTL) can be programmed for Fire Alarm,
Fault, Pre-Alarm or Plant Warning CBE Rules.
Factory Default = Fire Alarm - All Zones.
Unmonitored Output (volt-free style relay Circuit).
Can be programmed for Fire Alarm, Fault, Pre-Alarm
or Plant Warning CBE Rules.
Factory Default = Unmonitored Relay.
Unmonitored Output (dry-contact style relay Circuit).
Can be programmed for Fire Alarm, Fault, Pre-Alarm
or Plant Warning CBE Rules.
Factory Default = Unmonitored Relay.
Unmonitored Output Circuit. Can be programmed for
Fire Alarm, Fault, Pre-Alarm or Plant Warning CBE
Rules.
This output is normally used to drive an external relay.
Factory Default = General Pre-Alarm
Unmonitored Output Circuit. Can be programmed for
Fire Alarm, Fault, Pre-Alarm or Plant Warning CBE
Rules.
This output is normally used to drive an external relay.
Factory Default = Plant Warning
2
×
2
2 8
4
1