SETUP
ENTER
Selecting the Audio Output Mode
You must setup the audio output mode correctly, if not, you will
not get the audio outputs. The default setting is DIGITAL/RAW.
DIGITAL/RAW
If the OPTICAL output on the rear panel is connected with a
receiver built-in Dolby Digital, DTS or/and MPEG decoder,
select this item.
DIGITAL/PCM
If the OPTICAL output is connected with a recorder which
accepts PCM audio signal, select this item.
ANALOG
If the OPTICAL output is not connected with any equipment,
select this item.
1
Press the SETUP button to enter SETUP MENU. Use the 5/b
buttons to select AUDIO SETUP, and then press ENTER button.
GOTO AUDIO SETUP
2
Highlight AUDIO OUT using the 5/b buttons, then press the
t buttons to go to the right option list. Select DIGITAL/RAW,
DIGITAL/PCM or ANALOG using the 5/b buttons, then press
the ENTER button to confirm your selection.
AUDIO OUT
DYNAMIC
MAIN PAGE
ONLY ANALOG OUTPUT
3
Press the SETUP button again to exit menu.
Notes
< If the DIGITAL/RAW is selected and the audio source is LPCM
(DVD), the output in the OPTICAL is PCM.
< If the DIGITAL/RAW is selected and the audio source is audio
CD, the output in the OPTICAL is PCM.
< If the ANALOG is selected, the OPTICAL will not have audio
outputs.
< When playing a CD with no blank intervals recorded between
songs, there are occasions when audio available at DIGITAL
OUT stops momentarily.
http://www.bjjdwx.com/forum.php
79ÍøÂç http://www.79wl.com
DVD
g/t/5/b
SETUP MENU - - MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
- - AUDIO SETUP - -
DIGITAL/RAW
DIGITAL/PCM
ANALOG
Basic Setup 2
Selecting the Video Output Mode
You must setup the video output mode correctly, if not, you will
not get the video outputs. The default setting is S-VIDEO.
S-VIDEO
Select this setting when S-VIDEO OUT is connected.
COMPONENT
Select this setting when COMPONENT VIDEO OUT is
connected.
1
Press the SETUP button to enter SETUP MENU. Use the 5/b
buttons to select GENERAL SETUP, and then press the ENTER
button.
GOTO GENERAL SETUP PAGE
2
Highlight VIDEO OUTPUT using the 5/b buttons, then press
the t button to go to the right option list. Select S-VIDEO or
COMPONENT using the 5/b buttons, then press ENTER to
confirm your selection.
SCART
3
Press the SETUP button again to exit menu.
SETUP MENU - - MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
- - GENERAL PAGE - -
TV DISPLAY
TV TYPE
VIDEO OUTPUT
S-VIDEO
ANGLE MARK
COMPONENT
OSD LANG
SCR SAVER
MAIN PAGE
13