Video Out - Teac PL-D200V Service Manual

1) Connector the channel-1 scope probe to the Head S/W Pulse Test pin(j151).
2) Connector the channel-2 scope probe(1V/div.)to the Video out(R527).
3) Play back the Alignment Tape (Color Bar Signal Or Monoscope signal).
4) Adjust the PG Volume for interval of 6.5H±0.5H.
H.SW PULSE

VIDEO OUT

X-POSITION
*Measuring Point:J150(TEST Envelope)
*Adjust Point:X-POSITION ADJUST BOSS
1) Connector the channel-1 scope probe (1V/div.)to the Video Envelope Test Pin(J150).
2) Playback the Alignment Tape(Color Bar Signal OR Monoscope Signal).
3) Operating CH Up/Down Key of Remote Controller during Playing back Manual Tracking
Center Bar OSD to br the center of Screen.
4) Please Make Video Envelope Signal connected CH1 a Maximum Waveform
by Adjusting X-Posion BOSS.
5) Please Check Manual Tracking OSD is in the Center of Screen After Auto-Tracking.
6) If the posion is misadjusted, Please repeat from 1) to 5).
158
T=6.5 ±0.5 [H]
V.SYNC