Teac PL-D2200 Owner's Manual page 8

SUBWOOFER
C
CAUTION
Turn off the power of all the equipment before making
connections. Read instructions of each component you intend to
use with this unit.
Be sure to insert each plug securely. To prevent hum and noise,
do not bundle the connection cords with the power cord or
speaker cord.
A
SPEAKERS
< Connect the provided speaker cables (or other suitable cables)
from the speaker terminals to the terminals of the amplifier. Be
sure to match the color of the cables with the color of the
terminals.
< Be sure that the positive + terminal of the speaker is
connected to the corresponding + terminal of the amplifier,
and that negative _ matches _.
< When connecting to an amplifier having an output higher than
the maximum rated input of the speaker, be careful not to
exceed the speaker's maximum input, otherwise it will damage
the speaker.
8
http://www.bjjdwx.com/forum.php
79ÍøÂç http://www.79wl.com
FRONT
CB
AUDIO IN
SURROUND
How to connect:
Press the lever, insert the stripped and
twisted end of the cord, then release the
lever. Make sure it is fastened securely by
pulling the cord lightly.
Connection 3
CENTER
Y CR
COMPONENT
VIDEO OUT
A
B
B
SUBWOOFER PRE OUT jack
Connect the component with an RCA pin cable (monoral).
C
Power cord
< Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
< Hold the power plug when plugging or unplugging the power
cord.
< When the cord is plugged in, a small amount of current
continues to flow to the unit, even when the power is turned
off. Unplug the power cord from the AC outlet when the unit
isn't in use for some time.
FRONT
C
SURROUND