Access Point Settings - Nokia 9300i User Manual

the service provider. The user name is often case-
sensitive.
• Password — A password may be needed to
connect to the Internet, and is usually provided by
the service provider. The password is often case-
sensitive.
4. After defining the settings, press
advanced settings, if necessary. Otherwise, press
Finish or Done to exit the setup wizard.
Configuring advanced Internet

access point settings

Press Advanced when you have finished setting up the
basic Internet access point settings. The pages and
options available depend on the connection type you
have selected.
IP configuration page
Note that the two protocols (IPv4 and IPv6) require
slightly different settings.
• Network type (for GPRS only) — For a GPRS connection
you must specify which protocol you want to use.
• Auto retrieve IP — If you select Yes, the IP address is
obtained automatically from the server. This setting is
also called dynamic IP address.
• IP address — The IP address of the device. If the IP
address is obtained automatically, you are not
required to enter details here.
• Auto retrieve DNS
protocol, the DNS (domain name server) address is
obtained automatically from the server. The respective
90
Advanced to define
— If you select Yes for the IPv4
value for the IPv6 protocol is
Internet service that translates domain names such as
www.nokia.com into IPv4 addresses like
192.100.124.195, or IPv6 addresses like
3ffe:2650:a640:1c2:341:c39:14. If you select
IPv4 protocol, or Manual
must specify the IP addresses for the primary and
secondary DNS servers.
Proxies page
You may want to use a proxy to quicken access to the
Internet. Some Internet service providers require the use
of Web proxies. Contact your Internet service provider to
determine proxy details.
If you have made an Internet connection to your
company's intranet, and are unable to retrieve Web pages
from the general Internet, you may need to set up a proxy
server to retrieve Web pages outside your company's
intranet.
Define the following:
• Proxy protocol — Select the protocol type of the proxy.
You can set different proxy settings for each protocol.
• Use proxy server — Select
• Proxy server — Enter the IP address of the proxy
server, or the domain name. Example domain names
are: company.com and organisation.org.
• Port number — The number of the proxy port. The port
number is related to the protocol. Common values are
8000 and 8080, but vary with every proxy server.
• No proxy for — Define the domains for which the HTTP
or HTTPS proxy is not needed.
Well known. DNS is an
No for the
for the IPv6 protocol, you
Yes to use the proxy server.