Advanced Internet Access Point Settings For Packet Data (Gprs); Set Up An Access Point For Wlan Manually - Nokia E71 User Manual

Access point name
•
access point. The name is usually provided by
your service provider.
User name
•
by the service provider. User names are often
case-sensitive and provided by your service
provider.
Prompt password
•
password each time you log into a server or
to save the password in your device memory and
automate the login.
Password — Enter your password if required by
•
the service provider. The password is often case-
sensitive and provided by the service provider.
Authentication
•
password always encrypted, or
your password encrypted when possible.
Homepage
•
you want to display as the home page when you
use this access point.
4. After defining the settings, select
Advanced settings
settings or Back
Advanced internet access
point settings for packet
data (GPRS)
Select Menu Tools
>
Access points.
70
— Enter the name for the
— Enter your user name if required
— Select Yes to enter your
— Select Secure to send your
Normal
— Enter the web address of the page
Options
to define the advanced
to save the settings and exit.
Settings Connection
> >
After setting up a basic internet access point for packet
data (GPRS), select
and define the following advanced settings:
Network type
•
protocol type. The internet protocol defines how
data is transferred to and from your device.
Phone IP address
•
device. Select
No
provide the device IP address. This setting is shown
only if you select
DNS address
•
Secondary DNS address
addresses, if required by your service provider.
Otherwise, the name server addresses are provided
automatically.
to send
Proxy server address
•
proxy server. Proxy servers are intermediate servers
used by some service providers between a browsing
service and its users. These servers may provide
additional security and speed up access to the
service.
>
Set up an access point for
WLAN manually
1. Select Menu
Connection
2. Select Options
new access point, or select an existing access point
>
from the list and then
point to use the access point as a basis for the new
one.
3. Define the following settings.
Options Advanced
>
— Select IPv4 or IPv6 as the internet
— Enter the IP address of your
Automatic to have the network
Network type > IPv4.
— Select Primary DNS address
and enter their IP
— Enter the address of the
Tools Settings
> > >
Access points.
>
New access point
>
Options Duplicate access
>
settings,
and
to create a