Murano Beads Set Installation - Valor 1500IN Installation & Owner's Manual

QUALIFIED
INSTALLER
Material required
• Middle platform brackets (supplied with appliance)
• Small container to distribute glass beads
• Murano Beads Set, which contains:
◊ 2 bags of Glacier Ice fi rebeads
◊ 1 glass bead tray
IMPORTANT: For safety reasons, use only the
fi rebeads provided with your Valor fi replace or the
fi rebeads brands American Fireglass™ or fi regear.
The use of any other fi rebeads products may void
your fi replace warranty.
Installation
Carefully unpack the kit.
1. Install both middle platform brackets on front and
rear of the burner, with the tabs upwards fi tting the
end platform supports' protruding dimples into the
slots of the brackets as indicated.
Top
Bottom
2. Install the glass bead tray on top of the brackets as
indicated. The tray, when installed properly, is fl ush
with the front edge of the fi rebox opening. As well,
the small round hole in the tray should be at the rear
left when facing the fi rebox.
Installed tray
46

Murano Beads Set Installation

Small round
hole at rear
left of fi rebox
Edge of tray fl ush
with edge of fi rebox
3. Carefully spread the fi rebead in the tray and on the
burner. Do not overfi ll the burner to avoid blocking
the burner ports. Ideally, one layer of fi rebeads on
the burner is suffi cient.
Pilot shield
Beads installed—top view
NOTE: Ensure the area around the pilot shield is
not piled too high with fi rebeads and also ensure the
area within the pilot shield is clear of fi rebead.
Pilot shield
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi rebeads as these could be
ingested by small children. Vacuum area after
installation.