Liners Installation - Valor 1500IN Installation & Owner's Manual

The liners install in the manner outline below.
Note: The enamel liners require additional preparation
as indicated in instructions packed with the liners.
Unpack the liner panels carefully.
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors (one per side)
just enough to allow them to rotate.
2. Remove the top panel support located in the center
of the fi rebox at the top edge (2 screws).
3. Place the rear panel, beveled edge on top, on the
ledge above the ports of the rear of the fi rebox. The
panel sits on the ledge behind the tabs.
4. Place the left panel against the left wall of the fi rebox.

Liners Installation

5. Place the right panel against the right wall of the
fi rebox.
6. Tighten the side panel anchors on each side of the
fi rebox.
7. Insert the top panel over the top of one of the side
panels as far as possible. Rotate the other end of
the top panel upwards and pull it back to rest on the
other side panel. Center the top panel and push as
far back as possible to rest it on the rear panel.
NOTE: If the space is too tight, the top panel can be
installed before the right panel. In this case, install
the right panel last.
8. Reinstall the top panel support (2 screws).
QUALIFIED
INSTALLER
41