Connecting The Ac Adapter - Gateway E-100M Technical Reference Manual

Connecting the AC adapter

You can run your notebook using an AC adapter or your
notebook's battery. The battery was shipped to you partially
charged. You should use the AC adapter right away to fully
charge the battery. Allow three hours for the battery to fully
charge.
user-replaceable or user-serviceable parts inside. The AC adapter has dangerous
voltages that can cause serious injury or death. Contact MPC about returning
defective AC adapters.
or one of the same type purchased from MPC. Replace the power cord if it
becomes damaged. The replacement cord must be of the same type and voltage
rating as the original cord or your notebook may be damaged.
power for the first time, the battery life may be much shorter than you expect.
If the battery life seems short even after being charged for three hours, the
battery may need to be recalibrated. For information on recalibrating the battery,
see "Recalibrating the battery" on page
To connect the AC adapter:
1
14
CHAPTER 3: Setting Up and Getting Started
Warning
Do not attempt to disassemble the AC adapter. The AC adapter has no
Caution
Make sure that you use the AC adapter that came with your notebook
Important
If the battery is not fully charged before you use your notebook on battery
Connect the power cord to the AC adapter.
41.