Invacare XTERRA GT User Manual page 68

CAUTION:
• When connecting the battery cable/ring terminal(s) to the battery(ies) clamp(s), the battery
cable(s) must be connected in the position shown, otherwise damage may occur to the battery
cable and/or battery clamp covers.
3. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as follows:
• Negative (-) BLACK battery cable/ring terminal between the mounting plate and battery clamp
of NEGATIVE (-) battery terminal/post.
• Positive (+) RED battery cable/ring terminal between the mounting plate and battery clamp
battery clamp of POSITIVE (+) battery terminal/post.
4. Secure the battery cable(s)/ring terminal(s) to the battery clamp(s), BLACK to NEGATIVE (-) and
RED to POSITIVE (+), with existing hex screws. Securely Tighten.
5. Verify battery cable ring terminal(s) are correctly installed and securely tightened.
6. Slide battery clamp covers down battery cables and onto battery terminals.
7. Secure each terminal cap in place with a tie-wrap (Use tie-wraps 11-1/2-inches long).
NOTE:
It will be necessary to trim excess tie-wrap in order to install the battery box top(s).
8. Install the battery with lid into the wheelchair. Refer to INSTALLING/REMOVING BATTERIES W/
LID INTO WHEELCHAIR in this procedure.
68