Page 1
Operating Instructions TILTA MODELS: T1-6-2 T1-6HT T1-9HT As part of Parmco Appliances Ltd commitment to improving and updating product ranges, we reserve the right to alter, change and update technical specifications and appearance attributes of all Parmco Appliances. E&OE 727626092012...
Page 2
Parmco Appliances before any installation is carried out. We hope you enjoy your new appliance. If you would like to find out more about this product or any other products in Parmco’s extensive range, visit us on the web at www.parmco.co.nz. Regards,...
IMPORTANT SAFETY INFORMATION For best performance and to extend the life of your appliance we recommend that you read the instructions in this owners manual thoroughly before using your new appliance. It will provide you with all the information you need to ensure its safe installation, proper use and maintenance.
DO NOT use a steam cleaner to clean this appliance. Avoid improper or dangerous use of this appliance. Do not obstruct the ventilation or heat dissipation slots. This appliance is intended for indoor use only. Avoid exposing the appliance to atmospheric elements such as direct sunlight and rain.
Regulations concerning the discharge of air must be adhered to. Please refer to the relevant NZ standards. These hoods can be re-circulated using carbon filters available from Parmco Appliances. WALL FIXING ...
Page 6
Additional holes can be drilled through the rear of the unit to fix the unit to the packer if required. To adjust the bottom of the unit to the required depth use the screws located on the underside of the unit as per Fig 3 below. ...
Page 7
Push the retaining lugs (F) up until the lugs can be removed. Remove the lugs and gently lift the door assembly (E) upwards and outwards simultaneously. To replace the door reverse this procedure ensuring that the lugs have been replaced and are seated correctly with the curved portion of the lug facing towards the outside of the unit.
Operating Instructions The Tilta units can have the fan speed and lighting preset so that it automatically operates when the front cover is extended out. The unit can also be operated manually once the front cover is extended out. The Tilta units will not operate when closed.
minutes, then gently scrubbed to remove residues. Filters can be placed in the dishwasher when the detergent has a low caustic content. High caustic content dishwasher detergents may discolour the aluminium filters and result in premature failure of the aluminium mesh. Carbon Filters These filters contain activated carbon and cannot be cleaned.
Page 10
IMPORTANT: If the appliance is to be hardwired when making a fixed installation then a suitable cut-off device must be used to assure omnipolar disconnection of the mains. The cut off distance of the contacts must be at least 3mm. This appliance must be installed in full accordance with the Electrical Standards requirements of New Zealand.
09 573 5678 f: 09 573 5699 e: sales@parmco.co.nz w: www.parmco.co.nz Parmco Appliances extended 5 year warranty The Warranty: The Warranty is not valid: • If the product is not installed and operated in accordance with the operating • Subject to the terms and conditions contained within this instructions. warranty, if the product is not of Acceptable Quality (as • If the product is not installed to comply with the electrical, gas, plumbing defined in the Consumer Guarantees Act) within 5 years of and other Regulations and Codes of Practice in New Zealand. the date of original purchase, then Parmco Sales undertakes • If the product is operated on voltages or frequencies outside the normal range for domestic appliances in New Zealand. to repair or, at it’s sole discretion, replace the product.
Need help?
Do you have a question about the Tilta T1-6-2 and is the answer not in the manual?
Questions and answers
What hold the aluminium frame in place the aluminum frame holds the filter in place but I can't seem to get the frame back into place
help please Parmco Range hood model T1-6-2 I can't seem to get my aluminum filter support to stay up in the range hood and stay there what holds it in