Page 1
Installation and Operating Instructions Model: T7-6S-4 T7-9S-4 727623112020...
Page 2
Liability under this warranty will not be accepted for: Subject to updates without prior notice, please visit www.parmco.co.nz for E & O.E. 727626062017 the latest version.
Page 3
Dear Valued Customer, Thank you and congratulations on purchasing your new Parmco appliance. All Parmco products are made to the highest quality and design standards. We are sure you will enjoy your new appliance. As a note, please read through these instructions carefully. These will assist you appliance.
Thank you for purchasing this rangehood. Please read the instructions manual carefully before you use the rangehood and retain the manual in a safe place for future reference. Any installation work must be carried out by a qualified electrician. Before you use the rangehood, make sure that the voltage (V) and the frequency (Hz) indicated on the rangehood are exactly the same as the voltage (V) and the frequency (Hz) in your home.
1. The rangehood should be placed at a distance of 65cm above an electric cooktop or 75cm above a gas cooktop. 2. Cut a hole in the cupboard of 490 × 265mm for model T7-6S-4 and 715 × 265mm for model T7-9S-4. Make sure there is a minimum 35mm gap between the cutout edge and the cupboard edge.
Page 6
Changing the Light bulb 1. Switch the unit off and pull out the plug first. 2. Wait until the light bulb is cooled down before replacement. 3. Take out the filter and use the screw driver to take out the frame. 4.
Page 7
How to use the Control Panel here are five buttons: (Low), (Mid), (High), (Light), (Power). 1. After connecting to power, indicator light will lit on, all the output close and the hood will enter standby mode. The indicator light will be off automatically after reminding if no operation.
Page 8
light of middle button and power button will beam. Press middle button again and the motor will stop. Indicator light of middle button and power button will be off,and run by circle. 6. Press the (low) button once, motor runs on low speed, the indicator light of low button and power button will beam.
Maintenance 1. The rangehood and its filter mesh should be cleaned regularly in order to keep it in good working condition. As the grease filters are made of metal, do not clean the filters with detergents that will corrode metal products. 2.
Do not dry your rangehood using fire. If there are any faults with your rangehood, please call the Parmco service department at 09 573 5678. Do not exhaust the air from the rangehood through the same flue as the cooktop...
Troubleshooting Tips If any problem occurs, please remove the plug from the socket and contact Parmco service department at 09 573 5678. Problem Solution Restart the motor Lights work, but motor does not work Call Parmco service department Lights don't work, motor doesn't work...
Need help?
Do you have a question about the T7-6S-4 and is the answer not in the manual?
Questions and answers