Rear Panel - Sony F65 Operation Manual

Rear panel

a Recorder connector
Connects signal and power with the SR-R4 docked on the
camera.
Note
Attach the connector cap on the optical connector when
not connected to an SR-R4 to protect the connector.
b REC (record) indicator
The indicator is lit red while the recorder is recording.
You can slide the cover to hide the indicator.
c GENLOCK IN (external sync signal input)
connector (BNC type)
Used for input of an external gen-lock signal (HD 3-level
sync).
d SHUTTER (external shutter) connector
It is not used in this version.
e HD-Y OUT connector
Outputs the Y-signal for the HD analog component signal.
Used to synchronize external analog equipment.
f SDI OUT1 (SDI output 1) connector (BNC type)
Outputs an HD-SDI signal for connection to a monitor.
g REMOTE connector (8-pin)
It is not used in this version.
h DC IN (DC power input) indicator
A 10.5 V to 17 V indicator and 20 V to 30 V indicator are
provided. When the CAM POWER switch is turned ON,
the corresponding indicator lights up according to the
voltage of the power source.
a Recorder connector
b REC indicator
c GENLOCK IN connector
d SHUTTER connector
e HD-Y OUT connector
f SDI OUT1 connector
g REMOTE connector
h DC IN indicator
i DC IN connector
j Cable clamp screw holes
i DC IN connector (LEMO 8-pin)
Connects to a power cable with the supplied power cable
connector.
For details, see "2-6 Preparing the Power Supply" (page
21).
j Cable clamp screw holes
Can be used to attach the supplied cable clamp.
There are also screw holes on the upper surface on the left
panel side.
Locations and Functions of Parts
15