Setting The Sdi Out Output Lut; Selecting The Fan Operating Mode - Sony F65 Operation Manual

To set using the VF menu
Set the Color Temperature on the <Base Setting> page in
the Camera menu (page 39).
3-3-8 Setting the SDI OUT Output
LUT
The image output from the SDI OUT connectors is
configured using a Look-up table (LUT). The images shot
with the camera are intended for processing in post-
production, and are not suitable for checking the results of
shooting as-is on the scene. Setting a LUT changes the
tone of the image displayed on a monitor connected to an
SDI OUT connector, without affecting the main RAW
image output, for ease of monitoring. The following LUTs
can be configured.
Setting Description
709(800%) (default) Outputs a signal that extends the
dynamic range by up to 800% in
video terms based on ITU-R709 with
conventional monitor gamma.
S-Log Outputs a non-adjustable signal that
uses S-Log gamma.
1
Select the monitor look-up table on settings page 1,
then press the MENU SEL/ENTER dial.
Settings page 1
2
Turn the MENU SEL/ENTER dial to select the look-
up table to apply, then press the MENU SEL/ENTER
dial.
LUT
To set using the VF menu
Set on the <LUT> page in the VF/SDI menu (page 40).
3-3-9 Selecting the Fan Operating
Mode
You can set the operating mode of the camera's built-in
fans. The mode can be set to silence the fan speed noise or
to provided maximum cooling to suit the shooting
environment. You can select one of the following operating
modes.
Setting Fan operation
Auto1 The fans are automatically controlled
according to the internal temperature,
regardless of whether recording or not.
Auto2 The fans are automatically controlled
according to the internal temperature.
When recording, the fans are controlled
to maintain quiet operation.
Min In this mode, quiet fan operation is
maintained regardless of whether
recording or not. This is the best mode if
recording for more than 30 minutes in a
quiet environment, such as a concert
hall. Use this mode in environments with
ambient temperature of less than 30°C
(86°F).
Max (default) Fan rotation set at the maximum speed
to lower the internal temperature.
a) The coupling of the fan control with recording is available only when an
SR-R4 is docked on the camera.
Note
Even when Min mode is selected, the speed of the fans
automatically increases if the internal temperature rises.
1
Select the fan operating mode on settings page 2, then
press the MENU SEL/ENTER dial.
Settings page 2
Fan operating mode
10.8
24.OV
00:00:00:00
TCR
a)
Fan Mode
MAX
Media Rem
V
30
min
Basic Settings using the Subdisplay
29