Door Locks; Manual Door Locks - Chrysler Journey User Manual

• Do not touch the battery terminals that
are on the back housing or the printed
circuit board.
1. Battery access is through a door located on
the rear of the Key Fob. Insert a small, flat blade
screwdriver into the slot and gently pry open
the access door.
Battery Replacement
1— Battery Access
Door
18
2. Remove and replace the battery. Avoid
touching the new battery with your fingers. Skin
oils may cause battery deterioration. If you
touch a battery, clean it with rubbing alcohol.
3. Reposition the access door panel over the
battery opening and snap into place.
General Information
Transmitter and receivers operate on a carrier
frequency of 434 MHz as required by EEC
regulations. These devices must be certified to
conform to specific regulations in each indi-
vidual country. Two sets of regulations are
involved: ETS (European Telecommunication
Standard) 300–220, which most countries use,
and German BZT federal regulation 225Z125,
which is based on ETC 300–220 but has addi-
tional unique requirements. Other defined re-
quirements are noted in ANNEX VI of COMMIS-
SION DIRECTIVE 95/56/EC. Operation is
subject to the following conditions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference
received, including interference that may
cause undesired operation.
If your RKE transmitter fails to operate from a
normal distance, check for these two condi-
tions:
1. A weak battery in the transmitter. The ex-
pected life of the battery is a minimum of three
years.
2. Closeness to a radio transmitter such as a
radio station tower, airport transmitter, and
some mobile or CB radios.

DOOR LOCKS

Manual Door Locks

To lock each door, push the door lock plunger
on each door trim panel downward. To unlock
the front doors, pull the inside door handle to
the first detent. To unlock the rear doors, pull
the door lock plunger on the door trim panel
upward.