Remote Keyless Entry (Rke); To Unlock The Doors And Liftgate - Chrysler Journey User Manual

der "Personal Settings (Customer Program-
mable Features)," under "Electronic Vehicle
Information Center (EVIC)" in Section 4.
The interior lights will fade to off after approxi-
mately 30 seconds or they will immediately
fade to off once the ignition switch is turned
ON.
NOTE:
The illuminated entry system will not oper-
ate the interior lights if the Dimmer Control
is in the extreme downward (Defeat) posi-
tion.

REMOTE KEYLESS ENTRY (RKE)

This system allows you to lock or unlock the
doors and liftgate from distances up to about
35 ft (11 m) using a hand-held radio transmitter.
The transmitter does not need to be pointed at
the vehicle to activate the system.
NOTE:
Inserting the Key Fob into the ignition
switch disables all buttons on that transmit-
ter; however, the buttons on the remaining
transmitters will continue to work. Driving at
16
speeds 5 mph (8 km/h) and above disables
all transmitter buttons for all Key Fobs.
Remote Keyless Entry (RKE) Transmitter

To Unlock the Doors and Liftgate

Press and release the unlock button on the
transmitter once to unlock the driver's door or
twice within five seconds to unlock all doors
and liftgate. The turn signal lights will flash to
acknowledge the unlock signal. The illuminated
entry system will also turn on.
Remote Key Unlock, Driver Door/All Doors
First
This feature lets you program the system to
unlock either the driver's door or all doors on
the first press of the unlock button on the
transmitter. To change the current setting, pro-
ceed as follows:
• For vehicles equipped with the Electronic
Vehicle Information Center (EVIC), refer to
"RKE Unlock," under "Personal Settings
(Customer-Programmable Features)," under
"Electronic Vehicle Information
(EVIC)" in Section 4.
• For vehicles not equipped with the EVIC,
perform the following steps:
1. Press and hold the lock button on a pro-
grammed transmitter for at least 4 seconds, but
no longer than 10 seconds. Then, press and
hold the unlock button while still holding the
lock button.
2. Release both buttons at the same time.
3. Test the feature while outside of the vehicle
by pressing the lock/unlock buttons on the
transmitter with the ignition switch in the LOCK
position and the key removed.
4. Repeat these steps if you want to return this
feature to its previous setting.
Center