Chrysler Journey User Manual page 127

2. Fully depress the accelerator pedal
slowly three times within 10 seconds.
3. Turn the ignition switch to the LOCK
position.
NOTE:
• If the indicator message illuminates when
you start the vehicle, the oil change indi-
cator system did not reset. If necessary,
repeat this procedure.
• Performing reset procedure Steps 1
through 3 allows for a 12000 km service
interval for engine oil and filter changes.
16. Electronic Throttle Control (ETC)
Warning Light — If Equipped
This light will turn on briefly as a
bulb check when the ignition
switch is turned ON. This light will
also turn on while the engine is
running if there is a problem with
the Electronic Throttle Control (ETC) system.
If the light turns on while the engine is running,
safely bring the vehicle to a complete stop as
soon as possible, place the shift lever in PARK,
and cycle the ignition key. The light should turn
off. If the light remains lit with the engine
running, your vehicle will usually be drivable.
However, see your authorized dealer for ser-
vice as soon as possible.
If the light is flashing when the engine is
running, immediate service is required. In this
case, you may experience reduced perfor-
mance, an elevated/rough idle or engine stall,
and your vehicle may require towing.
Also, have the system checked by an autho-
rized dealer if the light does not turn on during
starting.
17. Oil Pressure Warning Light
This light shows low engine oil pres-
sure. The light will turn on and remain
on when the ignition switch is turned
from the LOCK or ACC position to the ON
position. The light will turn off after the engine is
started.
If the light does not turn on during starting,
have the system checked by an authorized
dealer.
If the light turns on and remains on while
driving, safely bring the vehicle to a stop and
shut off the engine. DO NOT OPERATE THE
VEHICLE UNTIL THE CAUSE IS CORRECTED.
This light does not show the quantity of oil in the
engine. The engine oil level must be checked
using the proper procedure. (Refer to "Check-
ing Oil Level" under "Maintenance Procedures"
in Section 7 for more information).
18. Charging System Warning Light
This light shows the status of the elec-
trical charging system. The light
should turn on when the ignition switch
is first turned ON and remain on briefly as a
bulb check. If the light stays on or turns on
while driving, turn off some of the vehicle's
electrical devices, such as the fog lights or rear
defroster. If the light remains on, it means that
the charging system is experiencing a prob-
lem. See your local authorized dealer to obtain
service immediately.
If jump starting is required, refer to "Jump
Starting Procedures" in section 6 of this
manual.
125