Chrysler Journey User Manual page 26

Window Lockout Switch
The window lockout switch on the driver's door
trim panel allows you to disable the window
control on the other doors. To disable the
window controls, press and release the window
lockout button (setting it in the down position).
To enable the window controls, press and re-
lease the window lockout button again (setting
it in the up position).
Window Lockout Switch
24
Reset
It may be necessary at some point in time to
reactivate the Auto-up/Auto-down feature. To
do so, perform the following steps:
1. Pull the window switch up to close window
completely and continue to hold the switch up
for an additional two seconds after the window
is closed.
2. Push the window switch down firmly to the
second detent to open the window completely
and continue to hold the switch down for an
additional two seconds after the window is fully
open.
Wind Buffeting
Wind buffeting can be described as the per-
ception of pressure on the ears or a helicopter-
type sound in the ears. Your vehicle may exhibit
wind buffeting with the windows down, or the
sunroof (if equipped) in certain open or partially
open positions. This is a normal occurrence
and can be minimized. If the buffeting occurs
with the rear windows open, then open the front
and rear windows together to minimize the
buffeting. If the buffeting occurs with the sun-
roof open, adjust the sunroof opening to mini-
mize the buffeting or open any window.
LIFTGATE
The liftgate can be unlocked or locked with the
Remote Keyless Entry (RKE) transmitter or by
activating the power door lock switch located
on either front door trim panel.
NOTE:
The liftgate cannot be unlocked or locked
with the manual door lock plungers on the
door trim panels or the door lock cylinder on
the driver's door.
To open the unlocked liftgate, squeeze the
handle and pull the liftgate toward you. Gas
props will raise and support the liftgate in the
open position.