Table of Contents
Advertisement
53 FX Loop II Send
Connect this FX Loop II output to a signal processor's input/return jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path,
FX Loop II
54 FX Loop II Return
Connect this FX Loop II input to a signal processor's output/send jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path,
FX Loop II
55 Balance
FX mix control for
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to
NOTE:
56
Low / High Gain - Volume Ratio Control: Channel 1
This knob adjusts the balance of volume levels between
and
Channel 1
in High Gain mode. Its setting affects
The volume level of
Volume knob (6) setting. Use knob 56 to dial in the relative volume to
High Gain mode.
57 Low / High Gain - Volume Ratio Control: Channel 2
This knob adjusts the balance of volume levels between
and
Channel 2
in High Gain mode. Its setting affects
The volume level of
Volume knob (24) setting. Use knob 57 to dial in the relative volume to
High Gain mode.
58 Low / High Gain - Volume Ratio Control: Channel 3
This knob adjusts the balance of volume levels between
and
Channel 3
in High Gain mode. Its setting affects
The volume level of
Volume knob (12) setting. Use knob 58 to dial in the relative volume to
High Gain mode.
59 Low / High Gain - Volume Ratio Control: Channel 4
This knob adjusts the balance of volume levels between
and
Channel 4
in High Gain mode. Its setting affects
The volume level of
is located post preamp and pre the two power amp Master knobs.
is located post preamp and pre the two power amp Master knobs.
FX Loop II
. When the knob is set to
Dry
when this loop is not in use!
Channel 1
in Low Gain mode is determined by the Channel 1
Channel 2
in Low Gain mode is determined by the Channel 2
Channel 3
in Low Gain mode is determined by the Channel 3
Channel 4
in Low Gain mode is determined by the Channel 4
Dry
, the amp signal is routed
Channel 1
in Low Gain mode
Channel 1
in High Gain mode only.
Channel 2
in Low Gain mode
Channel 2
in High Gain mode only.
Channel 3
in Low Gain mode
Channel 3
in High Gain mode only.
Channel 4
in Low Gain mode
Channel 4
in High Gain mode only.
Channel 1
in
Channel 2
in
Channel 3
in
23
Hide quick links:
Advertisement
Table of Contents
