Table of Contents
Advertisement
successfully. You can cancel the copy operation by releasing the key, but only for as
long as the LED lights up continuously. See page 27 and 28 f
IMPORTANT note; please read and heed
MIDI preset 1 activates when the amp is powered up. If you want to edit and/or store
other MIDI presets, you must connect a MIDI foot board or another MIDI send device
to the
MIDI In
port (44) and use this outboard device to select the desired MIDI preset
on the amp.
More good-to-know info:
Note that the Status LED also indicates the status of components unrelated to
and
Copy
. The microcontroller runs a short system check after you switch the amp on.
Should it find a defect in the memory chip (EEPROM), the LED
five short bursts.
Press the Write/Copy copy button to confirm that you got the message. Once you have
done this, the system will be ready to run, although you may encounter problems
when attempting to select or store MIDI preset.
Further indicator functions:
The Status LED serves a third display function. As described in section
that no speaker is connected to the power amp outputs.
36 Mute
This red LED lights up to show
silenced. Activate this mode via
preset, a MIDI controller #7 (or #28) command (see chapter 46 to learn more) or by
sending the appropriate Z-9 command to the Serial Amp Control Port (47). Deactivate
Amp Mute
by setting Standby (38) from
appropriate MIDI command to the MIDI In port (44) or via the respective Z-9
command (setting
A very IMPORTANT note; please read and heed:
ensure Standby switch is set to
preset to disable
sound. If the Standby switch is set to 0 during programming, the amp will be muted
when you select this MIDI presets precisely because the
enabled during programming. Therefore the power amp will not boost the signal and
the sound will not be audible over the speaker.
You cannot deactivate
Note:
programmed MIDI presets, MIDI controller commands or via the Z-9 when
engaged to switch the power amp off. You must first flip the Standby switch.
37 SWM
This blue LED lights up when the ENGL type Z-16 Sound Wizard module has been
installed in the amp's rear panel and enabled via the slide switch (1/SWM) on this
optional add-on module.
38 Stand By
Power amp standby switch: Use this switch to silence (0 position) the amp when you
take longer break. The amp's tubes stay nice and toasty, and the amp is ready to roll
16
Power Tube Monitor
Amp Mute
Standby
F2-4
) send to the Serial Amp Control Port (47).
On
Amp Mute
and enable the power amp so the speaker renders your
Amp Mute
:
; description in section
is engaged, that is, the power amp is
(set it to 0), a previously programmed MIDI
0
to
Power Amp On
When programming MIDI presets,
(that is, the power amp is active) if you want this
to activate the amp via appropriate
or more details
.
will flash in a pattern of
38.
38
, it indicates
or sending the
Amp Mute
function was
Write
Standby
is
Hide quick links:
Advertisement
Table of Contents
