Table of Contents
Advertisement
Each channel is equipped with a dedicated EQ so you can tweak its sound separately to
suit your taste and the given sonic scenario. Bear in mind that you also have the Sound
(1) button, as well as the two power amp Presence (14) and Depth Punch (15) knobs,
at your disposal for shaping the frequency range. Though this passive voicing section's
controls range is narrower than that of a comparable active system, its EQ curve is
tweaked specifically for its designated purpose, and will give you satisfying results.
12Volume3
Volume control for Channel 3's preamp section. Use this knob to adjust the volume of
Channel 3's preamp and dial in the desired balance with the other three channels' levels.
Becausethisknobislocatedpreeffectsloop,italsodeterminesthesendlevelsforbothFX
loopswhen
Channel3
Channel 3
is on. Use the knob (58) on the amp's rear panel to balance out the relative
volumesofHighGainandLowGainmodes.
13 CH 3
Press this button to activate preamp
the Channel 3 Volume knob (12) lights up to indicate
also be activated via MIDI program change, the ENGL Custom Z-9 Footswitch, or a dual
footswitch.
14 Presence
Power amp Presence knob. This knob determines the power amp's high frequency
response and affects all channels.
15 Depth Punch
This control shapes the lo frequency response in the power amp stage and affects all
channels.
16 FX LOOP I/II
This button switches to and fro between
the button lights up to indicate
program change or the ENGL Custom Z-9 Footswitch.
A tip from the designer:
Both effect loops can be configured in series (that is, 100% processed signal when
Balance
is set to
Balance
is set somewhere between
balance when
Balance
effect loops and switch from one effect device to the other using the FX Loop I/II
function, or employ just one of the two effect loops (for example, FX II Loop) and use
FX Loop I/II
to activate the effect. In the latter case,
its
Balance
knob to the
Master B
controls are post
10
isselected.TheredLEDtotherightoftheknoblightsuptoindicate
FX Loop II
wet
) or in parallel (1% to 99% mix of preamp and effect signal when
is set to
dry
dry
position). Note that in the signal path,
FX Loop Return
Channel 3
at the amp. The red LED to the right of
FX Loop I
and
is on. You can also select loops via MIDI
dry
and
wet
), or be bypassed altogether (0 % wet
). You can connect an effect device to each of the
and pre the power amp.
Channel 3
is active.
FX Loop II
. The red LED above
FX Loop I
serves as a bypass (set
Channel 3
may
Master A
and
Hide quick links:
Advertisement
Table of Contents
