Table Of Contents; Channel 3: Gain 3, Eq-3: Bass, Middle, Treble, Volume 3, Ch - Engl INVADER II Operator's Manual

Table of Contents

Introduction
Features and Functionality at a Glance
Contents
Front Panel Features:
Sound
Channel 1: Gain 1,EQ-1: Bass, Middle, Treble, Volume 1, CH 1
Channel 3: Gain 3, EQ-3: Bass, Middle, Treble, Volume 3, CH 3
Power Amp EQ: Presence A/B, Depth Punch
FX Loop I/II, Noise Gate
Input, High Gain
Channel 2: Gain 2, EQ-2: Bass, Middle, Treble, Volume 2, CH 2
Channel 4: Gain 4, EQ-4: Bass, Middle, Treble, Volume 4, CH 4
Power Amp section: Master A/B
Write/Copy, Mute, SWM LED
Stand By, Details on Amp Mute and the P.T.M. System, Power
Rear Panel Features:
Mains, Mains Fuse,
MIDI Section and Footswitch Ports
Noise Gate: Threshold Level
FX Loops I and FX Loop II: Send, Return, and Balance
Low / High Gain - Volume Ratio Control CH 1, CH 2, CH 3, CH 4
Pre Out, Line Out
Power Amp Output, 4, 8, 16 Ohms
Poweramp Output: speaker options
Practical Info and Tips
Handling and Care
Glossary
Status-LED: Indications
Troubleshooting
Detailed Specifications and Ratings
Technical Data,
Tube Map, Tube Exchange Service
Wiring of Principal Connectors
Remote Control Options
Front Panel Diagrams for Noting Settings
Configuration table for Z-9 settings
Front Panel and Rear Panel Diagrams
CAUTION! Please read and heed the following:
You'll find an ancillary pamphlet accompanying this owner's manual entitled
Instructions for the Prevention of Fire, Electrical Shock and Injury. Be sure to read it
before you plug in and power up the amp!
Technical specifications are subject to change without notice.
Note:
Ground Lift Switch
page :
4
5
6
6 - 8
8, 9
9, 10
10
10, 11
11, 12
12, 13
13, 14
14, 15
15, 16
16 - 18
18,19
19 - 22
22
22, 23
23
24
24
24, 25
25 - 28
28, 29
29, 30
30
31, 32
33
34
35
36
37
38
2, 39
3