Engl INVADER II Operator's Manual page 20

The following table shows the specific channel and OMNI settings of the small switches
labeled 1, 2, 3, 4 and 5 on the larger piano-type DIP switch.
MIDI-channel:
OMNI
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
CH 15
CH 16
MIDI controller access permission set with the small switch labeled '6' on the
larger piano DIP switch:
Setting the small switch labeled '6' to ON enables the MIDI controller access capability
for certain Amp functions.
Setting the small switch labeled '6' to OFF disables the MIDI controller access capability
for certain Amp functions.
A tip from the designer:
As the table indicates,
mode. Bear this in mind for practical applications, because this is a fast way to go from
a preset Poly channel to OMNI mode and vice versa.
MIDI Controller, Amp Mute
The small switch labeled '6' on the larger piano DIP switch determines if the amp
accepts MIDI commands so that MIDI controllers #7 or #28 can be used to mute it.
These controllers send
A value of 0 to 4 deactivates the Amp Mute command, thereby unmuting the amp and
reactivating at its current MASTER volume setting.
Note:
You cannot deactivate
controller #7 or #28 command when
You must first flip the Standby switch.
You can control the programmable functions
(17), High Gain (19) and
20
1: 2:
OFF XX
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
the small switch labeled '1'
an Amp Mute command when assigned a value of 5 or greater.
Amp Mute
Master A/B
3: 4:
XX XX
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
to activate the amp via an appropriate MIDI
Standby is engaged to switch the power amp off.
Sound
(34) as well as
5: 6:
XX XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
OFF XX
ON XX
switches between Poly and OMNI
(1), FX Loop I/II
Amp Mute directly using controller
(16), Noise Gate