Table of Contents
Advertisement
Configuring SNMP Trap Managers and Traps
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu → Configuration → Management and Communication →
SNMP Traps
2. Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address for each NMS Trap Manager to which traps will be sent.
— Specify the Initial Route Destination for each Trap Manager. The default is
AutoRoute.
— Select or disable trap categories, as needed.
3. Save the configuration.
Setting Up for In-Band Management
If FRF.8 Encapsulation Mode is set to Translational, remote management of the router
can still be accomplished in-band, as indicated in the following procedure.
The following procedure assumes that the router's Ethernet interface has already been
assigned an IP address that is in the same subnet as the management IP address
entered in
Step 6
configured for bridging only.
Refer to the iMarc SLV Configuration Reference and iMarc SLV Router Command Line
Interface for additional information.
on page 20 of
Using the Easy Install
Feature, and that the router is not
21
Advertisement
Table of Contents
