Configuring Snmp Trap Managers And Traps - Paradyne framesaver 9623 Installation Instructions Manual

Configuring SNMP Trap Managers and Traps

Once the FrameSaver unit is connected to the network, SNMP trap managers and
SNMP traps can be configured.
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu
SNMP Traps
2. Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address of the NMS(s) to which traps will be sent.
— Specify the Initial Route Destination for the Trap Manager(s).
— Select desired trap categories.
3. Save the configuration.
4. Return to the Main Menu.
Configuration Management and Communication
15