Checking Pvc Connections; Provisioning The Router Interface - Paradyne iMarc DSL 9783 Installation Instructions Manual

Checking PVC Connections

Check PVC connections to verify that all PVCs, including management PVCs, are
configured and active.
Procedure
To verify PVCs:
1. Select PVC Connection Status from the Status menu.
The PVC Connection Status screen shows all PVC connections, the interface
source and DLCI number of the incoming data linked to the interface, and DLCI
number for the outgoing data. You can also see whether the PVC is active.
2. Verify that each PVC is active.
— If active, the router should be passing data.
— If not active, no data traffic can be carried by the PVC. If the PVC is configured
correctly, the circuit may be down.

Provisioning the Router Interface

The iMarc DSL 9783 Router defaults to bridge mode. Routing without bridging, and
simultaneous routing and bridging, are also options.
Use the bridge command from the router's CLI to configure the bridge and routing
attributes. Also, enter an Ethernet IP address and a DHCP IP address. Refer to the
iMarc SLV Router Command Line Interface for more information.
24